4219 control unit pdf manual download. The 714/715 zones can be installed in. This installation guide provides instructions on setting up and using the honeywell wired zone expander module 4219
Control Panels & Keypads - Expansion Module
It includes information on how to install, connect, and program the module for compatible.
It has been type tested and found to comply with the limits for a class b computing device in accordance with the specifications in part 15 of fcc rules, which are designed to provide reasonable protection.
The module may be mounted within the control’s cabinet (if room permits), or remotely If mounted remotely, there are provisions to tamper protect the unit Communication to the module is supervised. Refer to the control’s installation instructions for specific information on how to program the control’s various.
Refer to the installation and setup guide for that control unit Set the dip switch to one of 16 addresses, as shown in figure 3, so the control can identify the module and communicate with it properly. With this module you can add an additional eight hardwired zones to your security system, and it supports aux power up to 125 ma. Keypad bus addressing expansion module
The next consecutive keypad address is automatically used to communicate the status of the next four zones (z nes 21 through 24
Expander zones 5 through 8. If a zone is not programmed, the resistor need not be used The method of programming each zone for the type of alarm and reporting code to the central monitoring station varies with the control to which. View and download dmp electronics 714 installation manual online
714 control unit pdf manual download The 714/715 zones can be installed in medium or high risk applications when two zones are used as shown in the dual zone protection diagram in the xr150/xr550 canadian installation guide. Determines zone a's response time On = normal (300ms) off = fast (10ms) response to an open 300ms zone a setting shown (as shipped)
Place the zone expander module in a listed enclosure and connect a dmp model 307 clip‑on tamper switch to the enclosure programmed as a 24‑hour zone
